 | | Re: Steering a robot
|
|
(...) This is a good starting point for a gear system that uses one motor to drive both wheels, and another that adds and subtracts rotations from the wheels to produce turning. (URL) subject has been covered a lot in earlier messages, so it may be (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | wall-follower using Dennis Clark's IRPD
|
|
Earlier this year I tried building a wall-follower using RCX's built-in IR port as the proximity detector. However I could not get consistent readings from the light sensor to make it work. I thought it was because the SendMessage trick did not turn (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | clutch gear
|
|
Is the motor kit the only way to get a clutch gear? Joel Shafer joel@connect.net -- Did you check the web site first?: (URL) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | Re: clutch gear
|
|
(...) No, but it's probably the cheapest, unless it's in a Dacta spare parts kit I don't know about. Target had the 3735s on sale for over 50% off. It's also in the 8479 Bar Code Multi set, but that's $160. These are the only two sets that have it (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Dark seeker project
|
|
I have finally built a creation with my Mindstorms kit that uses all of the sensors (some twice) and all of the motor connections! It has two bump switches for a collision detector on the front, one of my RCX IRPD modules to try to detect potential (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|