To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 4416 (-5)
  Re: NQC tutorial available
 
Mark, In the section on "Display", you mention "Setwatch()" is available in V2.3. Any guess when this will be available? Thanks, -Phil (...) (28 years ago, 30-Mar-99, to lugnet.robotics.rcx.nqc, lugnet.robotics)
 
  Re: Pneumatic Hand-Pump
 
(...) Well, I've actually built a compressor with one hand pump (with the spring removed). It was working, but I had to gear down the motor very much and the resulting compressor was very slow. You can see it employed in one of my robotic creatures (...) (28 years ago, 30-Mar-99, to lugnet.robotics)
 
  Re: square plates
 
(...) Scala has a 4x4 tile. Steve (28 years ago, 30-Mar-99, to lugnet.robotics)
 
  RE: Pneumatic Hand-Pump
 
(...) Ah yes, the brick separator of Technic - what to do with those hand pumps... I've tried to take them apart, not too hard to do with jewellers screwsdrivers to pry the tabs apart - carefully. Removing the spring wont get you much benefit (...) (28 years ago, 30-Mar-99, to lugnet.robotics)
 
  Re: Angle Sensor
 
Michel Verhagen wrote in message <000e01be788c$3c95fe...200mmx>... (...) "Potmeter" It is kind of crude for your application, but there are plans for building a homebrew LEGO rotation sensor off my web page. There is also a pretty good explanation (...) (28 years ago, 30-Mar-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR