 | | Program VB Light Sensor RCX
|
|
I am struggling with learning to program the RCX with Visual Basic. I want to have motor "B" run untill my light sensor "2" sees a level of 50. I am at a total loss on how to write this. Is there a site where I can down load some typical programs (...) (28 years ago, 26-Feb-99, to lugnet.robotics)
|
| |
 | | RE: Program VB Light Sensor RCX
|
|
Bob - Here's a VB program that does what you want. This assumes that Spirit .ocx is named "PbrickCtrl" as in the Mindstorm SDK examples. Substitute my statements in the "getstarted" example. I hope this helps! --- John. Private Sub DownPrgm_Click() (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Program VB Light Sensor RCX
|
|
In article <000001be61ff$638703...@toshiba>, John Brubaker <photoman@novagate.com> writes (...) [snip rest of program] That is an excellent example to demonstrate the use of VB to load a program; once you have got that working the next thing you (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | Might be new to Mindstorms
|
|
I'm tempted to get this set, though I don't know that much about programming, is this set easy enough to do things without that much knowledge? Or would I be better off getting the RC and a couple of motors to play with? or the BarCode truck? I know (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Might be new to Mindstorms
|
|
(...) IMNSHO, the Mindstorms software is pretty easy to use. It has its limitations, but it's good enough to learn the basics of programming, and once you're feeling the limitations, you'll be able to move to NQC or some such, by just learning a new (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|