 | | Re: FLASHING LIGHT ON LCD PANEL?
|
|
So using the Lego software I ran a small prg that reset all the variables. I still have that flashing quarter circle. do I need to reset it in NQC? and if so a sample code might help. Chris the guy with the lego brick tattoo or visit my lego walker (...) (26 years ago, 19-Jan-99, to lugnet.robotics)
|
| |
| | Re: FLASHING LIGHT ON LCD PANEL?
|
|
(...) The simplest solution is to reload the firmware. You can use the Lego software to do this. I'm almost positive you can reset if from inside NQC, but since I don't use NQC, I can't give you sample code. -Kekoa (26 years ago, 19-Jan-99, to lugnet.robotics)
|
| |
| | Re: FLASHING LIGHT ON LCD PANEL?
|
|
In NQC, just say: task main { SetDatalog(0); } I freaked when I first noticed the flashing pie chart, I thought my batteries were about to die. No big deal, except that my Probe robot was half way through a three hour scan of the Thunderbirds model! (...) (26 years ago, 19-Jan-99, to lugnet.robotics)
|
| |
| | Re: FLASHING LIGHT ON LCD PANEL?
|
|
Thanks Ben: this bit of code did the trick, I am now pie free. ;) i really gotta learn C. or just keep my fingers crossed and hope someone GTREAT at programming writes a Basic to NQC compiler. any takers? 10 clr 20 a = peek (sensor 1) 30 poke (out (...) (26 years ago, 19-Jan-99, to lugnet.robotics)
|
| |
| | Re: FLASHING LIGHT ON LCD PANEL?
|
|
In article <36A49D97.931256BD@myna.com>, Chris Magno <cmagno@myna.com> writes (...) Yes, me. If I spent less time reading lego-robotics and more time coding I would get there faster! I have written a qbasic program which will let you send bytecodes (...) (26 years ago, 19-Jan-99, to lugnet.robotics)
|
| |
| | Basic to NQC
|
|
HI: :) I never thought people would take that last bit so seriously. I can live without line numbers. I had to learn to not use them after I got a basic stamp. pervious to that all my programing knowledge came from my glorified microcontroler (an (...) (26 years ago, 20-Jan-99, to lugnet.robotics)
|
