Subject:
|
Re: FLASHING LIGHT ON LCD PANEL?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 19 Jan 1999 00:08:43 GMT
|
Original-From:
|
Chris Magno <cmagno@!NoMoreSpam!myna.com>
|
Viewed:
|
1260 times
|
| |
|
|
So using the Lego software I ran a small prg that reset all the
variables.
I still have that flashing quarter circle.
do I need to reset it in NQC?
and if so a sample code might help.
Chris
the guy with the lego brick tattoo
or visit my lego walker page at:
http://www.myna.com/~cmagno/technics/tech.htm
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message has 2 Replies:
 | | Re: FLASHING LIGHT ON LCD PANEL?
|
| (...) The simplest solution is to reload the firmware. You can use the Lego software to do this. I'm almost positive you can reset if from inside NQC, but since I don't use NQC, I can't give you sample code. -Kekoa (26 years ago, 19-Jan-99, to lugnet.robotics)
| | | Re: FLASHING LIGHT ON LCD PANEL?
|
| In NQC, just say: task main { SetDatalog(0); } I freaked when I first noticed the flashing pie chart, I thought my batteries were about to die. No big deal, except that my Probe robot was half way through a three hour scan of the Thunderbirds model! (...) (26 years ago, 19-Jan-99, to lugnet.robotics)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
