 | | Re: Worm gear... whence the length?
|
|
(...) Thanks Mark - those are nice designs. In my case I needed the precision, but I also needed a very compact implementation *and* it had to mount to an NXT motor: (URL) pretty happy with the design, but the slop really needed to be compensated (...) (16 years ago, 22-Jul-08, to lugnet.robotics)
|
| |
| | Re: Worm gear... whence the length?
|
|
(...) Hi Brian, If you're struggling with worm gaps for your leadscrew, this pic of my crane worm gearbox might help: (URL) worm is two worms long, plus two pairs of old type (crennellated) half bushes (small pulleys) and an old type 14-tooth bevel (...) (16 years ago, 22-Jul-08, to lugnet.technic, lugnet.events.brickworld, lugnet.robotics)
|
| |
| | Re: Worm gear... whence the length?
|
|
(...) That would make sense, but for the fact that the worm gear is ten years older than the gearbox that you cited. The only reason that the worm gear had to be made a tiny bit less than 2 studs long was so that when you put it between two TECHNIC (...) (16 years ago, 21-Jul-08, to lugnet.events.brickworld, lugnet.robotics)
|
| |
| | Re: NXT-G print to text?
|
|
(...) Nice defense! I'm sure the NI engineers have anticipated the complexities you've mentioned. Hence, no scary print-to-text. However, I'm not asking for anything so ambitious. I hold that a print-to-text within the context of plain NXT-G (no (...) (16 years ago, 21-Jul-08, to lugnet.events.brickworld, lugnet.robotics)
|
| |
| | Re: Worm gear... whence the length?
|
|
"Brian Davis" <brdavis@iusb.edu> wrote in message news:K49Az5.87G@lugnet.com... (...) The problems with the worm gear that you describe are due to the fact that it has to fit into this part in this set and others, which was designed to accomodate (...) (16 years ago, 20-Jul-08, to lugnet.events.brickworld, lugnet.robotics)
|
