| |
| |
Okay, thanks. I can get ‘Single output Mode’ to work now. ‘Single pin Mode’
may be working too, but I’m not sure what to expect from it.
I would expect setting either C1 or C2 would set them to 9V and run a motor
forwards or backwards. Setting them both would stop it.
But it seems if I set them, they do nothing. Unless the motor is already
running. If it’s running forwards at slow speed, then I set C1, it jumps up
to full speed. But then if I set C2 it keeps running, and if I clear C1 it
keeps running, and in the same direction.
Can you get a motor to run just be setting C1?
Jason R
|
i have not really spent a lot of time trying to figure these modes out. i was
more concerned with getting the PWM to work correctly. i’m going to spend more
time testing this and will let you know.
bob
|
|
Message is in Reply To:
17 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
