 | | Re: problem with rcx 2.0
|
|
(...) There is a good chance that the culprit is the entry fuse of the board. Check it with an ohmeter... This fuse is a tiny SMD one, rated 1.5A fast blow. It can be seen on this photo ((URL) in the lower right corner, between the long grey (...) (18 years ago, 14-Jun-07, to lugnet.robotics)
|
| |
| | Ultimate Builders Set instructions
|
|
I am looking for a copy of the instructions for the plotter found in the Ultimate Builders Set. Peeron does not have instructions for this set. Does anyone have a copy (or even an LDRAW dat file of the plotter would probably do) (18 years ago, 14-Jun-07, to lugnet.robotics)
|
| |
| | problem with rcx 2.0
|
|
Unfortunately, while working with the rcx open, a little piece of metal fall between the pins of the chip with a 16M6 written on top. It is to the left of the big capacitor and close to the small one. Has four legs, three in the front and one in the (...) (18 years ago, 13-Jun-07, to lugnet.robotics)
|
| |
| | NQC release 3.1r6 - support for 64-bit platforms
|
|
I have posted a new release of NQC which includes the fixes from r5 which were never officially released (aside from being included along with recent versions of BricxCC). It also includes a small source code change which makes it possible to (...) (18 years ago, 11-Jun-07, to lugnet.robotics.rcx.nqc, lugnet.robotics)
|
| |
| | Re: Control Lab - serial/USB
|
|
(...) I've tried two different converter cables (both say they work with modems, PDA's etc) but no luck with the CLI under RoboLAb. Before I run the program (which I have tested on my desktop PC and there it works) I select the COM port (which does (...) (18 years ago, 9-Jun-07, to lugnet.robotics)
|
