Subject:
|
Control Lab Interface response time
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 4 Jun 2007 18:43:41 GMT
|
Original-From:
|
linmix <linmix@gmail.^Spamless^com>
|
Viewed:
|
6342 times
|
| |
|
|
I finally got my CLI and did some simple testing today.
I realize the CLI isn't going to be quite as fast responding as the RCX
what with sending the information back to the PC etc etc, but I was
quite appalled by the lag between an input and the corresponding output.
It took almost a second for a motor to stop or start responding to a
touch sensor.
I'm starting to get the hang of RoboLab, but would I get better results
with another software?
I can see this lag could become quite problematic if I want any
precision in a setup controlled by the CLI. Can anyone give me any hints
as to how to minimize this problem?
Thanks in advance,
linmix
|
|
Message has 2 Replies:
 | | Re: Control Lab Interface response time
|
| (...) Whoah, a full second?! That's pretty useless! :( I'm trying to find software to program the ControlLab right now, but if this is the case, I might as well abandon any plans I had on using it. Fine motor control would be completly impossible. (...) (16 years ago, 5-Feb-09, to lugnet.robotics)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
