Subject:
|
Re: Control Lab Interface response time
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 14 Mar 2009 05:31:27 GMT
|
Original-From:
|
zapher <ZAP134@COMCAST.ihatespamNET>
|
Viewed:
|
11410 times
|
| |
|
|
CAN THIS BE CHECKED WITH DIFFERENT HARDWARE? PERHAPS THERE IS A LOOSE
CONNECTION OR BAD CHIP< SORRY FOR THE CAPS>
linmix wrote:
>
> I finally got my CLI and did some simple testing today.
> I realize the CLI isn't going to be quite as fast responding as the RCX
> what with sending the information back to the PC etc etc, but I was
> quite appalled by the lag between an input and the corresponding output.
> It took almost a second for a motor to stop or start responding to a
> touch sensor.
>
> I'm starting to get the hang of RoboLab, but would I get better results
> with another software?
>
> I can see this lag could become quite problematic if I want any
> precision in a setup controlled by the CLI. Can anyone give me any hints
> as to how to minimize this problem?
>
> Thanks in advance,
> linmix
>
>
--
View this message in context: http://www.nabble.com/Control-Lab-Interface-response-time-tp10955724p22509583.html
Sent from the LEGO Robotics mailing list archive at Nabble.com.
|
|
Message is in Reply To:
 | | Control Lab Interface response time
|
| I finally got my CLI and did some simple testing today. I realize the CLI isn't going to be quite as fast responding as the RCX what with sending the information back to the PC etc etc, but I was quite appalled by the lag between an input and the (...) (17 years ago, 4-Jun-07, to lugnet.robotics)
|
6 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
