Subject:
|
Re: iCommand 0.5 Setup/Test Problem
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 24 Nov 2006 21:23:13 GMT
|
Viewed:
|
3475 times
|
| |
|
|
In lugnet.robotics, Nick77 <nickbaker77@gmail.com> wrote:
> Ok so today I just tried again (did nothing differently) and it all worked
> fine - cool! Connected PC to NXT, then ran the test prog from Eclipse and I
> was driving the NXT around the floor 5 seconds later.
>
> I suspect my problem was something to do with needing to reset the NXT
> because of an unclosed connection, having read something about that last
> night.
A lot of people try to establish the connection between their PC and the NXT
first, resulting in <> on the LCD before they even run an iCommand program. This
results in the connection being busy and iCommand can't communicate. I suspect
this is what was going on.
- Brian
|
|
Message is in Reply To:
 | | Re: iCommand 0.5 Setup/Test Problem
|
| Ok so today I just tried again (did nothing differently) and it all worked fine - cool! Connected PC to NXT, then ran the test prog from Eclipse and I was driving the NXT around the floor 5 seconds later. I suspect my problem was something to do (...) (18 years ago, 19-Nov-06, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
