Subject:
|
Re: iCommand 0.5 Setup/Test Problem
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 19 Nov 2006 15:17:08 GMT
|
Original-From:
|
Nick77 <nickbaker77@gmailNOMORESPAM.com>
|
Viewed:
|
4620 times
|
| |
|
|
Ok so today I just tried again (did nothing differently) and it all worked
fine - cool! Connected PC to NXT, then ran the test prog from Eclipse and I
was driving the NXT around the floor 5 seconds later.
I suspect my problem was something to do with needing to reset the NXT
because of an unclosed connection, having read something about that last
night.
Nick
--
View this message in context: http://www.nabble.com/iCommand-0.5-Setup-Test-Problem-tf2657456.html#a7429923
Sent from the LEGO Robotics mailing list archive at Nabble.com.
|
|
Message has 1 Reply:
 | | Re: iCommand 0.5 Setup/Test Problem
|
| (...) A lot of people try to establish the connection between their PC and the NXT first, resulting in <> on the LCD before they even run an iCommand program. This results in the connection being busy and iCommand can't communicate. I suspect this (...) (18 years ago, 24-Nov-06, to lugnet.robotics)
|
Message is in Reply To:
| | iCommand 0.5 Setup/Test Problem
|
| Hi, Just trying out iCommand 0.5, following the instructions in the README file. Have done all steps (except the step "In Eclipse, select the RXTXcomm.jar you just added and expand it by clicking +..." as I can't see how you can expand a jar and (...) (19 years ago, 17-Nov-06, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
