 | | iCommand 0.5 Setup/Test Problem
|
|
Hi, Just trying out iCommand 0.5, following the instructions in the README file. Have done all steps (except the step "In Eclipse, select the RXTXcomm.jar you just added and expand it by clicking +..." as I can't see how you can expand a jar and (...) (18 years ago, 17-Nov-06, to lugnet.robotics)
|
| |
| | Re: iCommand 0.5 Setup/Test Problem
|
|
Ok so today I just tried again (did nothing differently) and it all worked fine - cool! Connected PC to NXT, then ran the test prog from Eclipse and I was driving the NXT around the floor 5 seconds later. I suspect my problem was something to do (...) (18 years ago, 19-Nov-06, to lugnet.robotics)
|
| |
| | Re: iCommand 0.5 Setup/Test Problem
|
|
(...) A lot of people try to establish the connection between their PC and the NXT first, resulting in <> on the LCD before they even run an iCommand program. This results in the connection being busy and iCommand can't communicate. I suspect this (...) (18 years ago, 24-Nov-06, to lugnet.robotics)
|
