Subject:
|
Re: Loading cargo from and to train electrically
|
Newsgroups:
|
lugnet.robotics, lugnet.trains
|
Date:
|
Tue, 17 Jan 2006 11:14:12 GMT
|
Viewed:
|
3870 times
|
| |
|
|
In lugnet.robotics, Elroy Davis wrote:
> I played a bit with stopping a train at a station. I had a loop of track
> powered off from a normal speed regulator. One section of track next to the
> stop was isolated elecrically by putting tape over the rails before connecting
> them. I powered this single section of track off from the RCX, which would
> allow me to stop and start it.
>
> As you mentioned, this leaves two motor outputs. I was thinking of using one to
> power a forklift-shaped pusher to load the train, and another to unload. I
> hadn't really though much about the cargo slipping off the waggon on other parts
> of the layout though. Using tiles, I can see how the cargo might slide off the
> car if it takes a corner too quickly. I might have to play with that a bit.
>
> -Elroy
Funny how oceans apart we come up with the same ideas. I stopped using light
sensors for the RCX and laterly use an isolated track to stop trains at two
stations. The third ouput being used for a level crossing.
I really like the loader idea, and the suggestion of mini-figures on a plate was
awesome.
|
|
Message is in Reply To:
9 Messages in This Thread:
  
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
