 | | Re: Loading cargo from and to train electrically
|
|
(...) I too had thought about something similar. I had got much past the specs though. I wanted a system that only used one rcx per station. One channel would control the train leaving me with only two remaining. I'd never thought of a system which (...) (18 years ago, 9-Jan-06, to lugnet.robotics, lugnet.trains)
|
| |
| | Re: Loading cargo from and to train electrically
|
|
(...) I played a bit with stopping a train at a station. I had a loop of track powered off from a normal speed regulator. One section of track next to the stop was isolated elecrically by putting tape over the rails before connecting them. I powered (...) (18 years ago, 9-Jan-06, to lugnet.robotics, lugnet.trains)
|
| |
| | Re: Loading cargo from and to train electrically
|
|
(...) How accurately? If you want to do this for a bunch of cycles, it would seem to me you need to control the position of the train quite exactly. The GBC train uses a simple bump sensor, and both Steve & I got train positioning to within 1 stud, (...) (18 years ago, 9-Jan-06, to lugnet.robotics, lugnet.trains)
|
| |
| | Re: Loading cargo from and to train electrically
|
|
(...) Funny how oceans apart we come up with the same ideas. I stopped using light sensors for the RCX and laterly use an isolated track to stop trains at two stations. The third ouput being used for a level crossing. I really like the loader idea, (...) (18 years ago, 17-Jan-06, to lugnet.robotics, lugnet.trains)
|
