To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 24839 (-5)
  Re: mindstorms NXT
 
(...) I *hope* that they use of BT will allow one control source (like my iBook ;) to control multiple NXT units simultaneously. The mind boggles ! Ray (21 years ago, 6-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) from the botmag page... "A special version for school and institutional use is also releasing later this year." (URL) (and better) than the consumer version ? Ray (21 years ago, 6-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) My conclusion that the bus is multipurpose stems from the evidence that there is a speed sensor (optoencoder of some sort?) on the motors. I presume that means that the motor ports have both output (motor control) and input (sensor feedback). (...) (21 years ago, 5-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) Sure, but that's only a benefit if you're attaching it direct to shatever needs the high torque. If you need some kind of transmission (which will probably be often with such big motors) the advantage is lost. ROSCO (21 years ago, 6-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT
 
(...) If you look at the picture of the new motor, you may notice that the orange disk with the cross axle hole in the center appears to be a single piece with four pin holes in addition. This might give the impression that the available torque may (...) (21 years ago, 6-Jan-06, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR