To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 23849 (-10)
  Re: GPS Reality?
 
Its worth pointing out that there has been recent discussions on the DPRG list about small scale location - a discussion which started off on GPS. I think it has now progressed to a system combining three sonar beacons, which are broadcast a radio (...) (22 years ago, 10-Apr-05, to lugnet.robotics)
 
  Re: Gearbox
 
(...) Since you're using a pendulum, why not use an escapement like a clock? The pendulum permits the release in one direction of a certain amount of rotation of the escapement wheel, which is spring or elastic-band powered. An important thing to (...) (22 years ago, 9-Apr-05, to lugnet.robotics)
 
  Re: RCX and R/C combined
 
(...) Hi Steve, I built this little resistor bridge out of 10K resistors for a similar application: (URL) Note: You can't see it in the photo, but the 1x4 electrical plates on the underside of the 2x4 plate have been cut in half so you can attach a (...) (22 years ago, 9-Apr-05, to lugnet.robotics, FTX)
 
  Re: GPS Reality?
 
(...) It's probably possible - making an infra-red transmitter to sit on the GPS side would get you there if the GPS could be made to run at a low enough baud rate. Alternatively, you could modify the RCX to take in RS-232 directly...but that's (...) (22 years ago, 9-Apr-05, to lugnet.robotics)
 
  Re: GBC 6 - the obsession continues...
 
Hi Danny, (...) that shouldn't be impossible, but just adding a motor was easier. Jürgen (22 years ago, 9-Apr-05, to lugnet.robotics)
 
  Re: RCX and R/C combined
 
(...) snip (...) I'm only intending to use standard gear motors. Great answear Mark, that's exactly what I wanted to know. Steve (22 years ago, 9-Apr-05, to lugnet.robotics)
 
  Re: My First MOC
 
(...) Rather than asking everyone to email you replies, you may want to look into subscribing to the group (perhaps temporarily) by email, via this URL: (URL) first doing this subscription setup: (URL) to get your confirmation code ) XFUT (...) (22 years ago, 9-Apr-05, to lugnet.robotics, lugnet.technic, lugnet.admin.general)
 
  My First MOC
 
Pictures should be forthcoming in a few days of my first official MOC, the überCrawler. This is a 2 RCX, 6 motor beast that turns by raising itself via a two-motor winch. It has four independently-powered tracks, coupled into a front and rear pair (...) (22 years ago, 9-Apr-05, to lugnet.robotics, lugnet.technic)
 
  Gearbox
 
Does anybody have diagrams, pictures, etc., regarding a "one-way" gearbox? This would have ideally one input and one output shaft, and the output shaft would turn the same direction no matter which direction the input was turned. Like a rectifier (...) (22 years ago, 9-Apr-05, to lugnet.robotics)
 
  GPS Reality?
 
Is the idea of a GPS sensor compatible to the sensor ports an absurd idea? I have a few old Garmin units, with RS232 ports on them. I know of people who have incorporated these units successfully into "real" robots, but that usually involves heavy (...) (22 years ago, 7-Apr-05, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR