 | | Re: caster wheel design
|
| (...) How heavy is this? A caster needs an offset, but making this offset as small as possible should reduce bending. I usually use a medium pulley on a #3 axle; either end of the axle is held in the pin hole of a Technic crossblack, while short (...) (20 years ago, 30-Mar-05, to lugnet.robotics)
| | | | | Re: caster wheel design
|
| If you are planning on running on smooth surfaces, you might be suprised at how well your robot drives and turns with just one of those domed 2x2 'gliders' instead of a wheeled caster. ---...--- Steve Baker ---...--- HomeEmail: (...) (20 years ago, 30-Mar-05, to lugnet.robotics)
| |
