To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 23344 (-5)
  Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
 
(...) The range of the Lego temperature Sensor is -20o C to 70 o C. You can see one reading below. As you can see, I'm almost off limit. (URL) (...) From my test, definitely the sensor would go off range first. Probably that's the reason why TLC (...) (22 years ago, 15-Jan-05, to lugnet.robotics, FTX)
 
  Re: Technic plates
 
(...) The shank with the dimension is galled up but it fits the 3/16" hole in the bit racks - I've got more than a few sets of drill bits and loose ones hanging around. I simply looked for the bit that provided a good fit (no slop) in a stack of 8 (...) (22 years ago, 15-Jan-05, to lugnet.technic, lugnet.robotics)
 
  Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
 
(...) Phew, I can feel the heat! What was the reading recorded by the temperature sensor? As I recall the LEGO Temperature sensor range is from -20 degrees Celsius to +50 degrees Celsius. Would the sensor go off range or would the ABS melt first? CS (22 years ago, 15-Jan-05, to lugnet.robotics, FTX)
 
  Re: MOC: Egglift, a Lego Appliance to cook soft-boiled eggs
 
(...) I think it was 'Ben' Beneke if thats any help, but his site has moved fairly recently. Tim (22 years ago, 15-Jan-05, to lugnet.robotics, FTX)
 
  Re: Technic plates
 
As I might have noticed, the Lego technic holes are exactly 4.8mm. This technique is also good to create "technic bricks" - very usable when you need a more stabilized axle-guide. Just drill a standar 2X* brick through the cilinders from the bottom, (...) (22 years ago, 14-Jan-05, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR