To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 23184 (-5)
  Re: RCX IR Transceiver and Sensor Port Circuits
 
Hi Mark, (...) I would also like to see your diagrams. (...) Please use GIF or PNG, jpegs are not so good for diagrams. Jürgen (22 years ago, 23-Dec-04, to lugnet.robotics)
 
  Re: Replacement Firmware Released
 
(...) Indeed, it vibrates fine if you set nMotorTransitionDelay = 0 Philo (22 years ago, 23-Dec-04, to lugnet.robotics)
 
  Re: Replacement Firmware Released
 
(...) Agreed. Beeing able to control break strength is an interesting feature, but it is incompatible with standard firmware. Maybe it should be controlled by a variable similar to bFloatDuringInactiveMotorPWM (22 years ago, 23-Dec-04, to lugnet.robotics)
 
  Re: Replacement Firmware Released
 
(...) I did exactly the same thing today, and found I needed a figure of about twenty to acheive reliable back and forth motion. I think it may be something to do with the fact that the rcx firmware(s) will not let you switch motor direction (...) (22 years ago, 23-Dec-04, to lugnet.robotics)
 
  Re: Replacement Firmware Released
 
I too am impressed with the amount of work that went into this release. After a few days playing around with it, I have a few comments: 1) braking seems to be proportional to power (at power=0, brake is not very effective) -- Lego firmware appears (...) (22 years ago, 23-Dec-04, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR