To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 23058
23057  |  23059
Subject: 
Re: Compact synchro Drive
Newsgroups: 
lugnet.robotics, lugnet.technic
Date: 
Sun, 28 Nov 2004 19:15:28 GMT
Viewed: 
1973 times
  
I will apreciate a lot for any opinion, comment or advice about this
project.

http://www.omiccron.com.br/lego/

To avoid half bush cutting, you could have used this thin 14 tooth gear
(http://peeron.com/inv/parts/4143) as a washer!

Philo



Message has 1 Reply:
  Re: Compact synchro Drive
 
Philo, It´s a good idea, I never have seen this gear before. But the last set it comes with this gear date from ten years ago, so i think there is not a chance to get 4 of these... I will see in e-bay, who knows. Thanks for the tip, Patrick (...) (20 years ago, 28-Nov-04, to lugnet.robotics)

Message is in Reply To:
  Compact synchro Drive
 
Hi all, I just finished my "compact synchro drive". I started this project some weeks ago, and i was studing an alternative to the always used turntables (that turns the entire robot into a large, fat and heavy being). This model is very compact, (...) (20 years ago, 28-Nov-04, to lugnet.robotics, lugnet.technic)  

13 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR