To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 22579 (-5)
  Re: Power saving on L293D???
 
(...) Looking in an old Maplin catalogue from 1998, the entry for the L293D shows a total quiescent logic supply current of 16mA per chip, so 48mA total. Presumably you're using a 9V logic supply to match the RCX outputs? The output supply current (...) (22 years ago, 6-Jul-04, to lugnet.robotics)
 
  Power saving on L293D???
 
Hi, I'm building my own controller to use with Mindstorms. I want to support 6 motors, with 3 L293D IC's. But I found that this IC needs about 25 - 30 mA on the logic supply, when the chip is disabled. That means even if I dont use any motors the (...) (22 years ago, 6-Jul-04, to lugnet.robotics)
 
  Re: RCX firmware vs hardware
 
(...) No, that won't cause any problems. The software versions are all interchangable between the RCXs, so you can use 1.0, 1.5 or 2.0 software/firmware on 1.0, 1.5 or 2.0 RCXs. I have both 1.0 and 2.0 RCXs, and I use the same firmware on both. (...) (22 years ago, 6-Jul-04, to lugnet.robotics)
 
  RCX firmware vs hardware
 
All, I've got an RCX 1.0, and my son has a 1.5. Is there anything that would cause problems if I loaded 1.5 firmware into a 1.0 RCX? While on the topic, what about 2.0 firmware in a 1.0 RCX? (22 years ago, 6-Jul-04, to lugnet.robotics)
 
  Re: Repairing small 9v battery box
 
(...) Hmmm, difficult. After a quick inspection, I'd say no. (...) What batteries are you using? I doubt there's many 9V batteries that can take sustained 5A for very long. ROSCO (22 years ago, 4-Jul-04, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR