 | | Re: Legway and Robolab
|
|
(...) While I agree this sounds like a fun project, don't be too disapointed if things don't go as well as you hope. I did some testing with NQC, and I found the standard firmware to be too slow to balance a Legway. I'm not going to say it can't be (...) (21 years ago, 8-Dec-03, to lugnet.robotics)
|
| |
| | Re: Legway and Robolab
|
|
(...) I spent a couple of evenings with a Legway, EOPD sensors and Robolab. I could not get it to balance or reach any condition of stability. I eventually 'gave up' because I felt that the violent control actions would destroy my motors :) Steve, (...) (21 years ago, 10-Dec-03, to lugnet.robotics)
|
| |
| | Re: Legway and Robolab
|
|
(...) Apparently, the standard firmware imposes a 100ms delay before a motor can change directions (ostensibly to protect the motors). This might be the source of some of the instability. Dick Swan suggests a possible way around the delay at the (...) (21 years ago, 10-Dec-03, to lugnet.robotics)
|
| |
| | OT Re: Legway and Robolab
|
|
--- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system ((URL) 6.0.548 / Virus Database: 341 - Release Date: 12/5/2003 (21 years ago, 10-Dec-03, to lugnet.robotics)
|
| |
| | Re: OT Re: Legway and Robolab
|
|
(...) Outgoing mail is certified Content Free Deleted by MIN anti-content system ((URL) 1.0.013 / Content Database: <nul> - Release Date 12/10/2003 FUT lugnet.off-topic.fun (21 years ago, 10-Dec-03, to lugnet.robotics, lugnet.off-topic.fun)
|
