Subject:
|
Re: RCX 2.0 circuit board changes
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 30 Aug 2003 21:15:00 GMT
|
Original-From:
|
Mike Thorn <buachaille@STOPSPAMMERSneo.rr.com>
|
Viewed:
|
972 times
|
| |
|
|
Phillippe,
Excellent, thanks a lot. That's exactly what I needed to know and the
pictures are crystal-clear. :-) So it only LOOKS really different...
Thanks again,
~Mike
At 08:01 PM 8/30/2003 +0000, you wrote:
> In lugnet.robotics, Mike Thorn wrote:
> > After reviewing some pictures of the RCX 2.0's circuit board today, I
> > noticed that they are quite different. Can anybody tell me the reason why?
> > What changed and how does it affect the RCX?
> >
> > I'm looking for that infamous diode that so often blows when someone tries
> > to build their own power supply. The boards are so different, though, that
> > I'm not even sure if it's there anymore. I need some better pictures before
> > I can draw a conclusion, though - the ones I have are small and rather • fuzzy.
> >
> > ~Mike
>
> Hello Mike,
>
> Here is a photograph (actually a scan) of all three versions (1.0, 1.5 and
> 2.0)
> of RCX: http://www.brickshelf.com/cgi-bin/gallery.cgi?f=38746
>
> I had a look at a few RCX 2.0 printed circuit boards, and at first sight they
> are identical. 1.0 contained the rectifier and regulator for external power
> supply, this was suppressed in 1.5. The other difference between 1.0, 1.5 and
> 2.0 comes from the suppression of diodes around Melexis motor drivers,
> there was
> a lot in 1.0, less in 1.5 and even less in 2.0. I guess (not sure, I haven't
> analyzed the circuit precisely) that these were protection diodes that proved
> unuseful.
>
> And the part that will blow for sure if you goof with power supply is the
> small
> surface mount fuse (rated 1.5A) that protects the board. It can be seen here
> http://www.philohome.com/motors/rcx1_5-top.jpg as a small transparent part in
> the lower right corner. Note that on the 2.0 PCB
> (http://www.brickshelf.com/cgi-bin/gallery.cgi?i=362264), I used a tiny
> wire to
> temporarily replacing the fuse, I was in short supply ;o)
>
> Cheers,
>
> Philo
> www.philohome.com
|
|
Message is in Reply To:
 | | RCX 2.0 circuit board changes
|
| After reviewing some pictures of the RCX 2.0's circuit board today, I noticed that they are quite different. Can anybody tell me the reason why? What changed and how does it affect the RCX? I'm looking for that infamous diode that so often blows (...) (21 years ago, 30-Aug-03, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
