To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 20919
20918  |  20920
Subject: 
Re: EGAD! (pneumatics)
Newsgroups: 
lugnet.technic, lugnet.robotics
Date: 
Mon, 16 Jun 2003 01:39:48 GMT
Viewed: 
715 times
  
Mark Tarrabain wrote:
> 
> c s soh wrote:
> > Is this what you're looking for?
> > A 3/8 RCX Output Multiplexer for the FT solenoid valves:
> > http://www.ozbricks.net/cssoh1/cpedia/ftmulti.htm
> > 
> > Btw, the circuit diagram is a piece of art from France :-)
> 
> Close.  What I would actually be wanting is eomthing that could use the
> voltage level being output from a *SINGLE* RCX port to do the
> addressing.  So for controlling up to four devices from one port, for
> example, would require that 25% power to the port control the first
> device, 50% the second, 75% the third, and 100% the fourth, and the
> direction of the current flow would determine whether I was wanting the
> addressed  device to be flipped one way or the other.  The devices would
> be such that when no control signals were being applied at all, they
> would retain their last set state (this may require a constant available
> power supply to the devices themselves, but I'm okay with that).   By
> dividing up the RCX motor voltages into even smaller divisions, I'm
> betting that you could probably control a dozen or more such devices.


Wow, that'll be great!

> To my understanding, the RCX uses pulse width modulation to actually
> control motor speed, so I'm thinking the first thing you'd need is a
> capacitor to even out an RCX output to a level voltage, then an ADC to
> convert that into a digital signal, and a demux to take that digital
> signal to address any one of several individual devices.  I don't own
> the appropriate hardware to try this idea out though.  If I did, I'd
> probably just do it myself and if it worked, I'd just announce it.

Keep at it.
--
C S Soh
http://www.ozbricks.net/cssoh1
       ....where air is power!



Message is in Reply To:
  Re: EGAD! (pneumatics)
 
(...) Close. What I would actually be wanting is eomthing that could use the voltage level being output from a *SINGLE* RCX port to do the addressing. So for controlling up to four devices from one port, for example, would require that 25% power to (...) (23 years ago, 15-Jun-03, to lugnet.technic, lugnet.robotics)

13 Messages in This Thread:




Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR