 | | Re: maze solving algorithm —Ralph Toepper
|
| | | Thanks for the reply, but this message was meant for Scott Davis regarding the configuration of his particular robot. Timothy Hello Timothy, hello Scott, and hello to all the others off course, i know. Those thougts i mentioned, are general (...) (21 years ago, 14-Jun-03, to lugnet.robotics)
|
| | | |
| | | | | Re: maze solving algorithm —Timothy Schroeder
|
| | | | | (...) Wood would make more sense instead of wasting a ton of legos on the walls (unless you have a ton of Duplos) (...) I gave a last option to Scott that allowed him to use a 5x5 map in the robots memory that only needed a reorientation algorithm (...) (21 years ago, 14-Jun-03, to lugnet.robotics)
|
| | | | | |
| | | | | Re: maze solving algorithm —Scott Davis
|
| | | | | For the robot design I used a synchro drive robot. On top of the robot is a distance sensor mounted on a technic turntable. I'll try to gets some pics of it for you. For the maze I used wooden (specifically 1/4" masonite) walls. I made it so that it (...) (21 years ago, 15-Jun-03, to lugnet.robotics)
|
| | | | | |
| | | | | | | Re: maze solving algorithm —Timothy Schroeder
|
| | | | | | | (...) So, does the robot work? Does it turn around and search the rest of the maze when it reaches the end? Timothy (21 years ago, 15-Jun-03, to lugnet.robotics)
|
| | | | | | | |
| | | | | | | | | Re: maze solving algorithm —Scott Davis
|
| | | | | | | | From: "Bluey" <Wolf_and_eagle@spam...yahoo.com> (...) maze (...) I forogt something. The robot was suppose to flood the maze starting in the finish square mapping how far each square is from the finish square. There is still some probelms with the (...) (21 years ago, 15-Jun-03, to lugnet.robotics)
|
| | | | | | | | |
| | | | | | | Re: maze solving algorithm —Jona Jeffords
|
| | | | | | (...) Can you post your source code please? Thanks, Jona <http:www.24tooth.com LEGO Robotics Group of Ann Arbor> (21 years ago, 16-Jun-03, to lugnet.robotics)
|
| | | | | | |
| | | | | version of firmware —Richard Diaz
|
| | | | Where can i see the version (1.5 or 2.0) of the firmware that is loaded into an RCX? thanks, Rich ___...___ Do you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! (URL) (21 years ago, 16-Jun-03, to lugnet.robotics)
|
| | | | |
| | | | | | gear pulley/release system —Richard Diaz
|
| | | | I have looked all over the forums and archives and still have not found quite what I am looking for. A cocking mechanisim for a cannon. I need a 1x16 beam (the 'bolt', held by rubber bands) to be pulled back and released down an 2x16 chamber pushing (...) (21 years ago, 18-Jun-03, to lugnet.robotics)
|
| | | | |
