Subject:
|
Re: DC Adapter Mod for RCX 2.0?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Mon, 12 May 2003 17:20:10 GMT
|
Viewed:
|
2839 times
|
| |
|
|
See that black thing at the far end of the ribbon cable (on the right in
the photo)?
That's a socket for a wall wart. I used the ribbon cable so that it
would come out of the battery compartment through the notch.
One thing you need to watch out for when building this: the pins on the
7809 are easily broken. I would suggest enclosing the whole thing
(regulator and pins) in a large piece of heat shrink tubing once you
have everything connected.
And one more thing, which I probably don't need to tell you: Watch your
polarity!
ObDisclaimer: I am not responsible if you damage your RCX as a result of
anything I talk about.
Matthew Keller wrote:
> Mark,
>
> Thanks for the reference. I was thinking more like adding a receptacle
> for a "standard" 9v wall wort. Perhaps I'm oversimplifying as I haven't
> yet cracked the case to see what's where, etc. Thanks again.
>
> On Mon, 2003-05-12 at 10:42, Mark Riley wrote:
>
> > Take a look at this post:
> >
> > http://news.lugnet.com/robotics/?n=17939
> >
> > I don't think it voids the warranty.
> >
> > Mark
> >
> > "Matthew Keller" <lego-robotics@crynwr.com> wrote in message
> > news:1052741898.1261.5.camel@comp6161.potsdam.edu...
> >
> > > Has anyone mod'd an RCX 2.0 to accept a DC powersupply? I've gone
> > > through the archives and have noted that there used to be one in the 1.0
> > > model, and lots of grumblings about it NOT being there in 1.5 and 2.0,
> > > but no one seems to have stepped up with a warranty-voider and fixed it
> > > (publicly) yet. If this is the case, I'll probably mod mine in the next
> > > few weeks and publish schematics/instructions one my website, and a note
> > > about it here. Any sage guidance is appreciated.
> > >
> > > --
> > > Matthew Keller
> > > Enterprise Systems Analyst
> > > Computing & Technology Services
> > > State University of New York @ Potsdam
> > > Potsdam, NY USA
> > > http://mattwork.potsdam.edu/
> > >
> > >
|
|
Message is in Reply To:
 | | Re: DC Adapter Mod for RCX 2.0?
|
| Mark, Thanks for the reference. I was thinking more like adding a receptacle for a "standard" 9v wall wort. Perhaps I'm oversimplifying as I haven't yet cracked the case to see what's where, etc. Thanks again. (...) (23 years ago, 12-May-03, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
