To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 19620
    Re: "real" LEGO Hovercraft ? (with/without batteries/RCX "onboard") —Rob Limbaugh
   A ducted fan approach may work. Ducted fan hovercraft have one or two big fan blades on the back that push the craft forward, but a duct takes some of the air and uses it to fill the skirt. This is probably the "lightest" design approach. Direction (...) (22 years ago, 27-Nov-02, to lugnet.robotics)
   
        Re: "real" LEGO Hovercraft ? (with/without batteries/RCX "onboard") —Jim Choate
     (...) Basic LCAC design. The air that drives the skirt is -not- derived from the direction fans but rather from the turbine input plenums (those babies will suck as much air in just a few 10's of sec. as goes through your entire house in year). If (...) (22 years ago, 27-Nov-02, to lugnet.robotics)
   
        Re: "real" LEGO Hovercraft ? (with/without batteries/RCX "onboard") —Steve Baker
     (...) That was the SRN1 - the worlds first working full-sized hovercraft - which (amazingly) didn't have a skirt. You can see a picture of it here: (URL) Steve Baker ---...--- HomeEmail: <sjbaker1@airmail.net> WorkEmail: <sjbaker@link.com> HomePage (...) (22 years ago, 27-Nov-02, to lugnet.robotics)
    
         Re: "real" LEGO Hovercraft ? (with/without batteries/RCX "onboard") —Jim Choate
     (...) Several of the original hovercraft didn't have skirts, they were the running board sitting on the ground. There is a simple childrens science experiment to demonstrate the effect. Take a sewing thread spool (the old wood kind work best) and (...) (22 years ago, 27-Nov-02, to lugnet.robotics)
   
        RE: "real" LEGO Hovercraft ? (with/without batteries/RCX "onboard") —Marco Correia
   Hi Rob :) (...) Yes, I *think* that's the only way. (...) That's my first approach. I'll deal with motion next. (...) 100% LEGO yes, but I'm planning on using LEGO (maybe ZNAP at first, then a mix of Technic) as the "wire-frame" and then use plastic (...) (22 years ago, 27-Nov-02, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR