Subject:
|
Re: rcx 2.0 without power plug !?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 6 Dec 2001 12:19:30 GMT
|
Original-From:
|
Quinton Delpeche <quintond@knowledgefactory.%Spamcake%co.za>
|
Reply-To:
|
QUINTOND@KNOWLEDGEFACTORY.CO.ZAihatespam
|
Viewed:
|
681 times
|
| |
|
|
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi,
Since RIS 1.5 the RCX no longer has the adapter for an external powers source.
Lego obviosuly did not change the design of some of the components of the RCX.
So in conclusion RIS 1.5 and 2.0 don't support external powers supplies on
the RCX.
Regards
Q
On Thu 06 Dec 01 14:16, Mathias Uhr wrote:
> hi guys!
>
> i got a brand new r.i.s 2.0 set (cheap :-), and now i'm
> a little confused:
> the rcx brick (it says "2.0" on it) has no connector for
> an external power source. i thought it should!??
>
> however, if i remove the dark grey bottom, the green
> battery holder has an opening in its "frame". it seems
> like it is prepared for holding a connector, but there's
> none built in...
>
> any ideas?
>
> some other questions:
>
> - my other rcx is from a r.i.s 1.5 set i bought new.
> however, it says "rcx 1.0" on the rcx brick. why?
>
> - can i use the 2.0 firmware (downloaded from lego
> or from the r.i.s 2.0 cd?) on all versions of rcx's
> (1.0, 1.5, 2.0)?
>
> - can i also use the software environment and the
> usb ir-tower from r.i.s 2.0 for all these rcx's?
>
> thanks a lot for any input!
> many greetings
> mat
>
> -- Did you check the web site first?:
> http://www.crynwr.com/lego-robotics
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org
iD8DBQE8D2JWggB5HV246nARAqRKAJ0WYT6vIx6lbJW2pCk2MQ1a/T1dmQCfZLsP
g5I1eN4yGvDddX/VR+p9FCc=
=c/ag
-----END PGP SIGNATURE-----
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
