Subject:
|
Re: Building a peripheral bus from motor output
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 26 Aug 2001 06:13:19 GMT
|
Viewed:
|
677 times
|
| |
|
|
In article <OF8FC5AF15.2DEF0298-ONC1256AB2.0073A448@svc-ag.net>,
"lego-robotics" <lego-robotics@crynwr.com> wrote:
> Ideas? Comments? Am I off the wall?
Id be surprised if you could pull 300baud, much less 2400, even assuming
perfect patterns.
But for low speed comm, it'd work... though I doubt any better than the
infrared port!
|
|
Message is in Reply To:
 | | Building a peripheral bus from motor output
|
| Hi all, I recently read an excellent paper by Fred Martin (of MIT fame) on building toys in a modular fashion. His microcontroller was similar to the RCX but had one key addition - a two wire serial bus so that active peripherals could be attached (...) (23 years ago, 25-Aug-01, to lugnet.robotics)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
