To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 16035
  Building a peripheral bus from motor output
 
Hi all, I recently read an excellent paper by Fred Martin (of MIT fame) on building toys in a modular fashion. His microcontroller was similar to the RCX but had one key addition - a two wire serial bus so that active peripherals could be attached (...) (23 years ago, 25-Aug-01, to lugnet.robotics)
 
  Re: Building a peripheral bus from motor output
 
(...) Id be surprised if you could pull 300baud, much less 2400, even assuming perfect patterns. But for low speed comm, it'd work... though I doubt any better than the infrared port! (23 years ago, 26-Aug-01, to lugnet.robotics)
 
  Re: Building a peripheral bus from motor output
 
(...) Do you have a link to this paper? We are taking a similar approach and using SPI on our JCX controller. We have designed in support for over 20 addressable I/O modules. For example, 4 motors are a module, 8 Lego compatible inputs takes up 2 (...) (23 years ago, 27-Aug-01, to lugnet.robotics)
 
  Re: Building a peripheral bus from motor output
 
(...) I don't to the paper, but the microcontroller in question is documented at (URL) . Hope it helps, Gordon (23 years ago, 27-Aug-01, to lugnet.robotics)
 
  Re: Building a peripheral bus from motor output
 
(...) (23 years ago, 27-Aug-01, to lugnet.robotics)
 
  Re: Building a peripheral bus from motor output
 
(...) It's at: (URL)We are taking a similar approach and using SPI on our JCX controller. We (...) I checked out the systronix.com website but didn't see anything about a JCX controller. Is it a Java version of the RCX? Did I miss the link? (...) (...) (23 years ago, 27-Aug-01, to lugnet.robotics)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR