Subject:
|
Re: Lego Dacta Control Lab software
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 22 Aug 2001 13:44:03 GMT
|
Viewed:
|
698 times
|
| |
|
|
ok, maybe not what you were looking for, but...
ROBOLAB 2.5 will support programming the Control Lab software in addition to
the RCX (including the Vision Command camera), and Scout.
If you already have ROBOLAB 2.0, you can download "LEGO Engineer" - a plug-in
to ROBOLAB 2.0 that programs the Control Lab software.
http://ldaps.arc.nasa.gov/LEGOEngineer/
both of these are mac and pc
In lugnet.robotics, Mark Hobba writes:
> Years ago I was building lego robots based on the Control Lab kit, with the
> software running on a Macintosh. The Mac is about to disappear, so I want
> to run the Control Lab off a PC now.
>
> Does anyone on this list have a Control Lab with PC software?
>
> thanks,
> Mark.
>
> (To email me, remove the "nospamto_" prefix from my address in the header,
> or reply here and I'll read it)
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Lego Dacta Control Lab software
|
| Years ago I was building lego robots based on the Control Lab kit, with the software running on a Macintosh. The Mac is about to disappear, so I want to run the Control Lab off a PC now. Does anyone on this list have a Control Lab with PC software? (...) (23 years ago, 21-Aug-01, to lugnet.robotics)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
