Subject:
|
Re: NQC software for Mac? (Robolab back ordered)
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 16 Dec 1998 22:59:49 GMT
|
Original-From:
|
Chris Osborn <fozztexx@+NoSpam+fozztexx.com>
|
Viewed:
|
1288 times
|
| |
| |
On Dec. 16 98, 13:57 PST, "Rob Visscher" <ffrob@knoware.nl> wrote:
> I'm also wrestling with the Mac problem. I'm looking for someone
> who tried getting it working with Virtual PC 2.0. The software
> runs perfectly, but i've got some trouble to communicate with the
> IR unit. I'm using a ordinary modem-cable to connect to the IR
> unit.
It will *never* work. The PC software fiddles with the RTS and CTS
pins, which the Mac *does not have*.
---
Chris Osborn FozzTexx Enterprises
707 226 7629 - Voice 2136 Coronado Ave.
707 253 3063 - Fax Napa, CA 94559
<fozztexx@fozztexx.com> <http://www.fozztexx.com/>
|
|
Message is in Reply To:
| | NQC software for Mac? (Robolab back ordered)
|
| hi bob I'm also wrestling with the Mac problem. I'm looking for someone who tried getting it working with Virtual PC 2.0. The software runs perfectly, but i've got some trouble to communicate with the IR unit. I'm using a ordinary modem-cable to (...) (26 years ago, 16-Dec-98, to lugnet.robotics)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|