Subject:
|
NQC software for Mac? (Robolab back ordered)
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 16 Dec 1998 21:57:45 GMT
|
Original-From:
|
Rob Visscher <ffrob@&StopSpam&knoware.nl>
|
Viewed:
|
1270 times
|
| |
|
|
hi bob
I'm also wrestling with the Mac problem. I'm looking for someone who
tried getting it working with Virtual PC 2.0.
The software runs perfectly, but i've got some trouble to communicate
with the IR unit. I'm using a ordinary modem-cable to connect to the IR
unit.
Do you have any ideas on this??
Thank in advance.
Rob Visscher
The Netherlands
ffrob@knoware.nl
|
|
Message has 1 Reply:
 | | Re: NQC software for Mac? (Robolab back ordered)
|
| (...) It will *never* work. The PC software fiddles with the RTS and CTS pins, which the Mac *does not have*. --- Chris Osborn FozzTexx Enterprises 707 226 7629 - Voice 2136 Coronado Ave. 707 253 3063 - Fax Napa, CA 94559 <fozztexx@fozztexx.com> (...) (26 years ago, 16-Dec-98, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
