 | | Re: Struggling with encoder wheel —Dean Hystad
|
| | | (...) I did an experiment printing out many different gradients and I now understand part of your problem. It was hard to get any change in the reading (~40 - 50). So next I then cut a wedge shaped slit in a piece of white paper. Aiming the sensor (...) (23 years ago, 13-Apr-01, to lugnet.robotics)
|
| | | |
| | | | | Re: Struggling with encoder wheel —Chris Osborn
|
| | | | (...) That was the first version of the webcam mount. After rotating back and forth a few times you can't tell where the camera is anymore. There also aren't any 42 tooth gears BTW, just a 40. Last night I used the datalog to record what the light (...) (23 years ago, 13-Apr-01, to lugnet.robotics)
|
| | | | |
| | | | | | Re: Struggling with encoder wheel —Dean Hystad
|
| | | | (...) I have noticed the lost count phenomenon also (you attribute it to gear slop on you web page, but gear slop will give you errors in the 1/2 a tooth range or less and it doesn't get worse over time). In fact there was a very long thread about (...) (23 years ago, 13-Apr-01, to lugnet.robotics)
|
| | | | |
