| |
Gaurav Thakur wrote:
>
> BTW I was just browsing your website (really great site BTW) and had a
> question...do you know what type of pressure gauge you used on the creation
> on the main page? I've been trying to find an air pressure measurement
> device which works with the Lego pneumatic system for some time now but have
> had no luck...
Well, the markings say "TIRE PRESSURE GAUGE" at the top and "TRU-FLATE"
at the bottom. It reads to 60 psi. No other markings to indicate its
manufacture.
It came courtesy of John Barnes together with the pressure sensor. The
inlet has been specially modified with a nozzle that will nicely fit the
Lego pneumatic tubing.
I think it is better than the Monkey Grip digital tire pressure gauge
that Michael Gasperi is using as it can provide continuous readings. But
I wouldn't rely too much on it as its accuracy is far short of the
silicon pressure sensor.
--
C S Soh
CSSoh's Lego Pneumatics
http://www.geocities.com/cssoh1
... where air is power!
|
|
Message has 1 Reply:
Message is in Reply To:
14 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
