 | | Re: Question about RIS 1.0
|
|
(...) Transformers do NOT convert AC to DC. They only convert AC to AC. The DC conversion is performed by four diodes in the RIS1.0. Maximum input is rated at 12V AC or DC (the diodes will take care of the polarity for DC inputs) although the (...) (24 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
| | Re: Question about RIS 1.0
|
|
(...) The RIS 1.0 can be run from either 12VAC or 12VDC. In either case an internal bridge rectifier supplies the internal circuitry with the proper polarity. Internal power is supplied through an LM2936M 5V regulator (maximum input of 45V BTW) The (...) (24 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
| | Re: Shutting off illumination LED on Light Sensor for LIDAR
|
|
(...) Actually you don't need LegOS, any input set to raw mode with the LEGO firmware will do fine. This is because even in passive mode there is a pull up of 10k to 5V, and in fact the LED is glowing dimly in this mode. Just tried it, I can get raw (...) (24 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
| | Re: Ideas for new sets?
|
|
(...) Pokemon Jürgen (24 years ago, 1-Apr-01, to lugnet.robotics)
|
| |
| | David Schilling
|
|
This has an unusual drive-train, I'd like to see what i does and how it moves. (URL) (24 years ago, 1-Apr-01, to lugnet.robotics)
|
