Subject:
|
Re: Solenoid Pnuematic Valve
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 9 Mar 2001 16:56:16 GMT
|
Viewed:
|
650 times
|
| |
|
|
On Fri, 15 Sep 2000 16:11:09 GMT, Jeffrey Hazen <jeffrey.hazen@northmill.net> wrote:
> I have finally found a tiny solenoid valve for use with the RCX. It fits
> into a 2x4 stud brick, and runs off one of the motor outputs. All I had to
> add was a resistor, a zener (the valve runs on 3 VDC), and a diode (reverse
> voltage stop). It's really neat. Did I mention it fits into a 2x4 brick?
Was it these valves ?
http://www.microhydraulics.com/EFSWEB/2186.htm
If not, they seem intersting, but I have no information about cost, availibility, efficency with RCX. I just found that
in a magazine.
Marc Klein
A Mindstorms fan.
|
|
Message has 1 Reply:
 | | Re: Solenoid Pnuematic Valve
|
| I'm no sure if those are the ones, but a long time ago somebody tried these: (URL) not sure of the results, but would be interested to find out about either of them. Martin ----- Original Message ----- From: "Marc Klein" <marc.klein@free.fr> To: (...) (24 years ago, 9-Mar-01, to lugnet.robotics)
|
Message is in Reply To:
| | Solenoid Pnuematic Valve
|
| I have finally found a tiny solenoid valve for use with the RCX. It fits into a 2x4 stud brick, and runs off one of the motor outputs. All I had to add was a resistor, a zener (the valve runs on 3 VDC), and a diode (reverse voltage stop). It's (...) (24 years ago, 15-Sep-00, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
