 | | pbForth is fun!
|
|
I had approached pbForth two or three times in the past, always failing to manage what I thought was a steep learning curve. The truth is I probably was too lazy to put the necessary attention into it, or I was in a hurry to program my robots to (...) (25 years ago, 22-Jan-01, to lugnet.robotics)
|
| |
| | Re: Interfacing Sharp's GP2D02 Distance Sensor to the RCX
|
|
am 22.01.2001 15:36 Uhr schrieb Ram Meenakshisundaram unter rmeenaks@olf.com: (...) Hi Ram, please have a look into the data sheets. Then you would say "... the GP2D02 is a very powerful sensor .... but the GP2D12 is better than the GP2D02 for using (...) (25 years ago, 22-Jan-01, to lugnet.robotics, lugnet.robotics.rcx)
|
| |
| | Interfacing Sharp's Distance Sensors to the RCX
|
|
Hi, I was searching a web page which gives an overview about all the sharp distance sensors. I 've found it. I 'm sure that some of yours will read it. (URL) 22.01.2001 15:36 Uhr schrieb Ram Meenakshisundaram unter rmeenaks@olf.com: (...) Hi Ram, (...) (25 years ago, 22-Jan-01, to lugnet.robotics, lugnet.robotics.rcx)
|
| |
| | Re: Ideal Tank Platform Was: adder-subtractor ????
|
|
(...) Ideally: Both motors should be driven in 'forward' direction so if one had a matched set of motors, you could perhaps achieve lateral speed balance. Forward end of tracks should be slightly elevated to grab and climb obstacles: <- Front * * * (...) (25 years ago, 22-Jan-01, to lugnet.robotics)
|
| |
| | Re: Gearing down a lego motor
|
|
from my experience it really depends on the application, if you are working on a walker it usually takes a minimum of 1:12 for most of mine, but i don't know waht you are doing. mike "rubbing the weekend out of his eyes" fusion (25 years ago, 22-Jan-01, to lugnet.robotics.rcx, lugnet.robotics)
|
