Subject:
|
Re: IR Tower problems
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 21 Jan 2001 20:13:09 GMT
|
Viewed:
|
1544 times
|
| |
|
|
In lugnet.robotics, Greg Ericksen writes:
> I recently purchased an IR tower to use with my Scout. It did not come
> with a cable, but the tower was only 6$(www.eblok.com), so I found a cable
> that could plug into the back of it. The other end of the cable fit into the
> printer plug on the back of my computer.
> I do not know if this will work, because when using Scouttool from the
> SDK, it says that the ghost cannot be initialized. I was wondering if there
> is anyway that I could find out if my computer recognizes the IR tower.
> If anyone knows how to test this, please reply.
> Thank You,
> Greg Ericksen
Hi Greg,
I'm not sure if the RCX IR Tower is the same than the Scout Tower, but I
guess it's so.
You can't use the printer port (LPT) for the tower. You have to use a serial
port (COM1, COM2, ..).
If you're not sure if you've got the right cable have a look at Kekoa
Proudfoots web site. There you'll find how to build (test) your cable.
You'll find the page here :
http://graphics.stanford.edu/~kekoa/rcx/#Hardware
Rainer
|
|
Message is in Reply To:
 | | IR Tower problems
|
| I recently purchased an IR tower to use with my Scout. It did not come with a cable, but the tower was only 6$(www.eblok.com), so I found a cable that could plug into the back of it. The other end of the cable fit into the printer plug on the back (...) (26 years ago, 21-Jan-01, to lugnet.robotics)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
