To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 13663
  Re: Message transmission speeds.
 
In the RCX and the tower, the IR receiver is located close to the transmitter. When the transmitter is running, the adjacent receiver's Automatic Gain Control cirucit (AGC) becomes saturated, and sets the receiver sensitivity to it's lowest possible (...) (24 years ago, 30-Dec-00, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
(...) (snip) (...) The data rate is 2400bps, and each packet of N bytes of data has 5 + N bytes of overhead. So the more realistic time to send a 1 byte message is 24ms. Here is an excerpt from the Communication section of (URL) Did you check the (...) (24 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
(...) Oops. Two mistakes there. (5 + 1 + 1)*4 = 28 not 24, which is moot because "messages" apparently have a prefix of hex F7 as part of the data payload, so a message is actually 9 bytes or about 36ms. Makes it sound like you're doing nothing (...) (24 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
(...) That sounds believable. I send 6 one-byte messages in each comms cycle. That's gotta be a good 150ms - which is probably about what I'm seeing. How depressing. :-( (...) So, the first major speedup would be to send a 3-byte message containing (...) (24 years ago, 1-Jan-01, to lugnet.robotics)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR