Subject:
|
Newsgroup
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 29 Dec 2000 15:55:12 GMT
|
Original-From:
|
Moorthy Karthikeyan <[mkarthik@cisco.]spamcake[com]>
|
Reply-To:
|
mkarthik@cisco.comSAYNOTOSPAM
|
Viewed:
|
865 times
|
| |
|
|
Hi,
I was wondering whether there is a newsgroup associated with this
mailing list? If there is'nt one, I would like to propose that we start
a newsgroup, as many of the wonderful solutions/answers we get in this
mailing list are not being archived and we cannot refer back to them
later. Also it will minimize the possibility of people asking questions
which have been already asked/answered to. A free newsgroup service like
http://www.egroups.com could be one of the options. Please share your
comments...
Cheers,
Moorthy
--
*** Cisco Systems, Inc. Moorthy Karthikeyan
*** | | Software Engineer
*** .|||. .|||. Email: mkarthik@cisco.com
*** .,;|||||||;,.,;|||||||;,.
|
|
Message has 2 Replies:
 | | Re: Newsgroup
|
| It is archived at www.lugnet.com... Ram ----- Original Message ----- From: "Moorthy Karthikeyan" <lego-robotics@crynwr.com> To: <lugnet.robotics@lugnet.com> Sent: Friday, December 29, 2000 10:55 AM Subject: Newsgroup (...) (24 years ago, 29-Dec-00, to lugnet.robotics)
|
Message is in Reply To:
| | Re: Motor wires
|
| If you are careful, you can open up one of the black electrical connectors and remove the wire. The wire is attached to the connector with insulation piercing points. It is not soldered. Just lift the wire out, and cut it to the desired length. When (...) (24 years ago, 28-Dec-00, to lugnet.robotics)
|
9 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
