 | | #9244 Universal joint
|
|
Is there a substitute for the #9244 Universal joint ? ((URL) not, how can I power something that moves slighty (like a wheel with suspention, etc) ? Is the only option to use the Znap flex connector ? Thxs for any info :) Marco C. aka McViper (...) (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | Re: Motor wires
|
|
If you are careful, you can open up one of the black electrical connectors and remove the wire. The wire is attached to the connector with insulation piercing points. It is not soldered. Just lift the wire out, and cut it to the desired length. When (...) (25 years ago, 28-Dec-00, to lugnet.robotics)
|
| |
| | Mars expansion set
|
|
Hi all Any feedback on whether the Mars expansion set is worth it? Thanks Mike Bird (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | MacNQC Not Recognizing Firmware File
|
|
I'm using MacNQC and when I try to download a firmware file I can't see the file in the "choose file" dialog, although I can plainly see the firmware file in the Finder. Any help would be most appreciated! (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | Re: EToys sale
|
|
(...) For sure eToys is in trouble financially... here is a couple of snippets from their SEC form 8-K filing: "As of September 30, 2000, we had an accumulated deficit of $339.9 million. We incurred net losses of $53.4 million for the quarter ended (...) (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | Re: 9V Lamp Source
|
|
(...) Try Train accessory <set:5308> or <set:5310> which may still be available from S@H. There is also a Dacta set of just two lighting bricks for $10, I think. Ben (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | 9V Lamp Source
|
|
Hello All! Where can I find a good source of the 9V lamps that are available in the Ultimate Accessory set, 3801? The lamp in question is 1x2 white brick with a small bulb. I'd like to get several of these, maybe in other colors (brick, not bulb) if (...) (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | Re: Power inlet to RCX 1.5?
|
|
You could use a voltage regulator at the adaptor output. You would not get anything above the rated voltage, but I do not know about lower voltages. Andy (...) (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | Re: Power inlet to RCX 1.5?
|
|
Some people already discussed it in the past but I don't remember nobody saying that it was already done. I'm very interested in this matter also. One idea was do use a wire with aligator clips connected to the internal baterry connectors. You may (...) (25 years ago, 29-Dec-00, to lugnet.robotics)
|
| |
| | Re: Digital Camera
|
|
(...) SECAM :) Marco C. aka McViper ___...___ Work mailto:mcviper@geocities.com Home mailto:mcviper@clix.pt (25 years ago, 29-Dec-00, to lugnet.robotics)
|
