 | | Re: Axle joiner angles —Amnon Silverstein
|
| | | I think these just correspond to the splines on the old connectors which they replace. I haven't checked it, but I think the splines are every 12.5 degrees. The connectors are too chunky to make accute angles, so they only do the obtuse angles: 0.0 (...) (24 years ago, 12-Dec-00, to lugnet.robotics)
|
| | | |
| | | | | Re: Axle joiner angles —Constantine Hannaher
|
| | | | Oops. It looks like in your list you exchanged the labels of #3 and #5. And it occurs to me that the splines had to be set so that the half bushings could be pushed together and lock when on the same axle. I would have to take a look to see if that (...) (24 years ago, 12-Dec-00, to lugnet.robotics, lugnet.technic)
|
| | | | |
| | | | | | Re: Axle joiner angles —Juergen Stuber
|
| | | | (...) Yes. (...) No. There are 16 splines, and the axle joiners come in increments of 360/16=22.5 degrees. (...) If you mean the single angle beam ((URL) angle is related to a 3/4/5 triangle, so that the longer side becomes the 5-side of the (...) (24 years ago, 13-Dec-00, to lugnet.robotics, lugnet.technic)
|
| | | | |
