 | | Re: Motorize Focus on Vision Command Camera
|
|
I works quite well! (URL) Fay rfay@we.mediaone.net The Shop (URL) Fay" <rfay@we.mediaone.net> wrote in message news:G3J75I.89A@lugnet.com... (...) (25 years ago, 5-Nov-00, to lugnet.robotics)
|
| |
| | Motorize Focus on Vision Command Camera
|
|
The glue is drying. Check it out at: (URL) sawed the tabs off the large half of the Big turntable and scraped the ridge from the center hole. The gear is braced and the glue has been applied. It will be driven with a micromotor and gear train. Tune (...) (25 years ago, 5-Nov-00, to lugnet.robotics)
|
| |
| | Re: AI in RCX
|
|
I think that you should not immediately discount the idea of nueral networks in the RCX. Bert van Dam has done amazing stuff with networks on the RCX, and using no PC code. The point of the RCX is to try, learn, and invernt, not to say that it is (...) (25 years ago, 5-Nov-00, to lugnet.robotics)
|
| |
| | Re: Motorized VC cam focusing
|
|
If you are willing to give up a half of a large turntable, you could glue the large geared half to the rubber on the camera and drive the gear with a motor on top of the camera. A 26t gear will mesh with a gear head motor on top, but it is a bit (...) (25 years ago, 5-Nov-00, to lugnet.robotics)
|
| |
| | Re: How2 'count' in NQC
|
|
I want to thank everyone who helped with the double problem of switch de-bouncing and that loops can often count continuously while the switch is in actuation. There were good suggestions about removing delays from the code and 'counting' upon (...) (25 years ago, 4-Nov-00, to lugnet.robotics)
|
