Subject:
|
Re: 2 RCX communication on the same model
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 9 Dec 1998 21:17:23 GMT
|
Viewed:
|
849 times
|
| |
|
|
Embarrassed...
I am just starting, and have been using the *Mindstorms* RCX code (that's my
problem); it doesn't send IR messages.
Since sending that post, I have downloaded and started to look at the
Gordon's Brick Command programming interface. It seems that it is no
problem for brick command to do this messaging. Sorry for the premature
post, and thanks for the answers.
LINC
|
|
Message has 1 Reply:
Message is in Reply To:
 | | 2 RCX communication on the same model
|
| If you set a motor_out to free wheel, and attached the output end to another RCX input for a touch sensor, could you simulate a touch event by turning of free wheel for a moment? If so is there any way that different messages could be sent like: (...) (26 years ago, 9-Dec-98, to lugnet.robotics)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
