Subject:
|
2 RCX communication on the same model
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 9 Dec 1998 19:52:01 GMT
|
Viewed:
|
954 times
|
| |
|
|
If you set a motor_out to free wheel, and attached the output end to another
RCX input for a touch sensor, could you simulate a touch event by turning of
free wheel for a moment? If so is there any way that different messages
could be sent like:
verbal code: (the only one I know) :-)
If touch sensor triggered /initiation of communication
do for x seconds
count presses of touch sensor
end loop
if count 1 then .... else if count 2 then... else....
I want to communicate between two RCXs (one mobility, and two sensory)
LINC
|
|
Message has 2 Replies:
 | | RE: 2 RCX communication on the same model
|
| (...) Um, you should be able to just point the RCX's ports at each other and talk via the IR link. What development environment are you using? check it's manual for the functions to send and receive bytes via IR. Cheers Tim (26 years ago, 9-Dec-98, to lugnet.robotics)
| | | Re: 2 RCX communication on the same model
|
| Embarrassed... I am just starting, and have been using the *Mindstorms* RCX code (that's my problem); it doesn't send IR messages. Since sending that post, I have downloaded and started to look at the Gordon's Brick Command programming interface. It (...) (26 years ago, 9-Dec-98, to lugnet.robotics)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
