Subject:
|
RE: 2 RCX communication on the same model
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 9 Dec 1998 20:13:38 GMT
|
Original-From:
|
Tim McSweeney <tim@ams.co.STOPSPAMnz>
|
Viewed:
|
2378 times
|
| |
|
|
> If you set a motor_out to free wheel, and attached the output
> end to another
> RCX input for a touch sensor, could you simulate a touch
> event by turning of
> free wheel for a moment? If so is there any way that
> different messages
> could be sent like:
>
> verbal code: (the only one I know) :-)
>
> If touch sensor triggered /initiation of communication
> do for x seconds
> count presses of touch sensor
> end loop
> if count 1 then .... else if count 2 then... else....
>
> I want to communicate between two RCXs (one mobility, and two sensory)
>
> LINC
Um, you should be able to just point the RCX's ports at each other and talk
via the IR link. What development environment are you using? check it's
manual for the functions to send and receive bytes via IR.
Cheers
Tim
|
|
Message is in Reply To:
 | | 2 RCX communication on the same model
|
| If you set a motor_out to free wheel, and attached the output end to another RCX input for a touch sensor, could you simulate a touch event by turning of free wheel for a moment? If so is there any way that different messages could be sent like: (...) (28 years ago, 9-Dec-98, to lugnet.robotics)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
