Subject:
|
Re: Strong gear assemble?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 22 Sep 2000 18:54:53 GMT
|
Original-From:
|
Tilman Sporkert <tilman@webmethods.comIHATESPAM>
|
Viewed:
|
802 times
|
| |
|
|
> P.s. whats the worm to 40pt ratio?
1:40. There's a single thread on the worm, moving one "tooth" per
revolution. That gives you the same ration as 1 tooth gear. As has been
discussed before, the characteristics of this worm gear reduction will be
slightly different than building a 1:40 reduction using normal gears.
Tilman
|
|
Message is in Reply To:
 | | Re: Strong gear assemble?
|
| Im ahead of you there, I already did that :p. I need to add even more torque. The the current setup is this: worm to central 40pt gear, 40pt's axle is connected to one 8pt gear on either end and then after that a 16 (i think)on each end also. The (...) (24 years ago, 22-Sep-00, to lugnet.robotics)
|
12 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
