 | | Re: Old & New Motors: work output comparison???
|
|
(...) There is a good page about this here: (URL) his tests found that the the new 9V geared motor provides at least twice as much torque at a similar RPM. In practice, some pretty amazing torque can be obtained with either, and sometimes I favour (...) (25 years ago, 15-Sep-00, to lugnet.technic, lugnet.robotics)
|
| |
| | Old & New Motors: work output comparison???
|
|
It's CRANE TIME ast Elwood & Bubbas' workshop. After a two year - hiatus, E & B are back at the drawing board, hard at work on their biggest crane ever. My quest is for performance measures of the old & new Lego motors: which one produces more work (...) (25 years ago, 15-Sep-00, to lugnet.technic, lugnet.robotics)
|
| |
| | Solenoid Pnuematic Valve
|
|
I have finally found a tiny solenoid valve for use with the RCX. It fits into a 2x4 stud brick, and runs off one of the motor outputs. All I had to add was a resistor, a zener (the valve runs on 3 VDC), and a diode (reverse voltage stop). It's (...) (25 years ago, 15-Sep-00, to lugnet.robotics)
|
| |
| | Details of pneumatic stuff inside Otto
|
|
(...) Kevin and others asked for some more details about the pneumatic devices inside my robot Otto. I just put some more pics on the page, hope they help: (URL) (25 years ago, 15-Sep-00, to lugnet.robotics)
|
| |
| | Re: My simple pneumatic switch
|
|
Looks good. Thanks for sharing. Ryan -- reply to: rjschave at home dot com (URL) <lego-robotics@crynwr.com> wrote in message news:B5E5F934.3FF1%a...one.net... (...) obvious (...) (25 years ago, 15-Sep-00, to lugnet.robotics)
|
